VOLTCRAFT VC940 - V06-09 Instructions d'exploitation télécharger pdf (Page 21)

MultiSystem 4010

Operating Instructions

Rev. 1.5 / 120816 english

Page 21 of 45

The current measured values are displayed after initialisation. You may select the shown channels in

the display menu. Use one of two display modes:

• measured values with units (left image)

• measured values with minimal and maximal values (right image)

The active display mode is displayed in the lower left corner. Press

to toggle the display mode

and

to stop the refresh of the values (“freeze” the display). Press again to enable the refresh.

Press

in MinMax mode to delete the extreme values. Then the new extreme values will be

measured instantly.

6.3. Main Menu

All settings and programmings of the instrument are done in the menu structure accessible from the

main menu. Press

to open it:

Use the arrow keys to highlight a menu and press

to open it:

Channels contains all commands and functions to program the channels of the instrument

Display select channels to be displayed and configure the display

Memory configure recordings and manage saved measuring data

Device general settings to adapt the instrument for your personal needs

When a menu is highlighted, the F-keys are occupied with several functions:

Quick access keys „Channel“ menu

opens the channel programming for the measuring channels C1 … C5

Quick access keys „Display“ menu

toggles the display modes „Text“ / „Graphic“

Quick access keys „Memory“ menu

starts the recording

opens the presentation menu where you can display recorded measuring data

opens the delete menu where you may delete recorded measuring data

Quick access keys „Device“ menu

enables or disables the defined filter settings

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 44 45

Pas de commentaire

VOLTCRAFT VC940 - V06-09 Instructions d'exploitation Page 21